VM Serial problem

Screenshot from 2020-03-29 21-16-32 Screenshot from 2020-03-29 21-25-57 Screenshot from 2020-03-29 22-00-46

I have created a VM and i just changed the pins of SERIAL1 and SERIAL2.

When i try communicate with SERIAL1, it only works with use the pins set to RX2 and TX2.

SERIAL2 does not work with any of serial pins set.

So Serial0 and Serial1 works, But Serial2 doesn’t ?

Yes, but SERIAL1 is using the pins set to SERIAL2(26 and 27).

Which board are you using @Tarciso?

I am using TTGO T-CALL board, that has ESP-WROVER-B. (https://github.com/Xinyuan-LilyGO/TTGO-T-Call)

But i also tested it with DOIT ESP32 DEVKIT V1 and had the same result.

Have you tried to switch the pins of Serial1 and Serial2 ?
Just to see if there are problems with the definitions or a problem with the Hardware.

Yes, and i tried others pins too. The result is the same, serial1 works using the pins set for serial2.